Dixon ZTR 4421 Manuel de l'opérateur télécharger pdf (Page 28)

CARE AND

MAINTENANCE - 4000 SERIES MODELS

DECK REMOVAL:

1. Place cut height lever in lowest cut position.

2. Pull belt idler back to allow belt to be removed from idler pulley and electric

clutch

pulley.

3. Remove hair pin cotter and washer from one end of deck support cross shaft.

Note

location of remaining shim washers used between chassis and mower deck pan arms.

Slide shaft from chassis and mower deck.

4. Remove hair pin cotter and washer -from each deck adjustment rod. Carefully

push each link toward the inside of the mower chassis. At this point, deck will

drop

down.

5. Carefully raise and support front of chassis. Slide mower deck to either side for

removal. (Reverse procedure to reinstall deck assembly).

NOTE:

When deck is reinstalled on frame, check that belt P/N 6111 is

correctly routed in the groves of all pulleys and that belt idler is

applying tension to the back side of the belt.

Page

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 38 39

Pas de commentaire

Dixon ZTR 4421 Manuel de l'opérateur Page 28